Check the following:

1.  Check whether all the program parameters are the same. (gradient, speed, ...)

Be careful when programming 0.0 8 C as gradient!  This means that the system will heat at maximum power.  When programmed like this, different heating behavior can be normal.  It will be dependent on lamp efficiency, lamp aging, interior cleaning, etc...  It is then better to program 4.0 8 C/minute instead of 0.0 8 C.  The controller will then monitor the real temperature in the unit. 

2.  Are you using the same beaker size?

3.  Are you missing stainless steel and black coated beakers?

4.  Do the reference beakers have the same content (liquor ratio, sample weight, ...)?

• ahiba_faq_4_different_results.pdf

1. My Ahiba Nuance Top Speed is cooling slowly, slower than it was new.
2. Where can I download Autolab Data?
3. My Ahiba IR or Ahiba ECO is cooling very slowly.
4. Can I mix stainless steel beakers with black coated beakers?
5. Can I always leave the reference beaker in the unit?
6. What do I have to do when the robot just stops? The robot just stops and doesn’t do anything.
7. AutoLab - The solution agitation belt is very noisy.
8. How do I backup the files for Autolab?
9. AutoLab - The dispense head crashes with all the bottles.
10. Guidelines on correct operation of AutoLab dispensers to ensure best dyeing results.
11. Why is the SPS dropping water?
12. AutoLab - The SPS does not reach the last water weight.